///////////////////

NFOUR=1024

EXPONENT=19

NNU=100 // number of neutrino events

NNU_PASSED=10 // number of neutrino events that are allowed to pass the trigger

ONLY_PASSED_EVENTS=1 // 0 (default): AraSim throws NNU events whether or not they pass; 1: AraSim throws events until the number of events that pass the trigger is equal to NNU_PASSED (WARNING: may cause long run times if reasonable values are not chosen)

NOISE_WAVEFORM_GENERATE_MODE=0 // generate new noise waveforms for each events

NOISE_EVENTS=16 // number of pure noise waveforms

TRIG_ANALYSIS_MODE=0 // 0 = signal + noise, 1 = signal only, 2 = noise only

DETECTOR=1 // ARA stations 1 to 7

NOFZ=1

TIMESTEP=5.E-10 // value for 2GHz actual station value

TRIG_WINDOW=1.E-7 // 100ns which is actual testbed trig window

POWERTHRESHOLD=-6.06 // 100Hz global trig rate for 3 out of 16 ARA stations

//DATA_BIN_SIZE=8192

POSNU_RADIUS=3000

V_MIMIC_MODE=0 // 0 : global trig is located center of readout windows

DATA_SAVE_MODE=0 // 2 : don't save any waveform informations at all

WRITE_ALL_EVENTS=0 // don't save any waveform informations to eventTree

BORE_HOLE_ANTENNA_LAYOUT=0

SECONDARIES=0

// below settings are available for only TestBed mode (DETECTOR=3 case)

TRIG_ONLY_BH_ON=0

CALPULSER_ON=0

USE_MANUAL_GAINOFFSET=0

USE_TESTBED_RFCM_ON=0

NOISE_TEMP_MODE=0

TRIG_THRES_MODE=0

READGEOM=0 // reads geometry information from the sqlite file or not (0 : don't read)

// new variables

//INTERACTION_MODE=0 // pickunbiased mode!

//GETCHORD_MODE=1 // use new icemc Getchord function

//taumodes=1

//BH_ANT_SEP_DIST_ON=0 // default 0 : use constant borehole antenna distance. 1 : use separate antenna distance. use z_btw01, z_btw12, ... in ARA_N_info.txt or ARA37_info.txt

TRIG_MODE=0 // use vpol, hpol separated trigger mode. by default N_TRIG_V=3, N_TRIG_H=3. You can change this values

//N_TRIG_V=4

//N_TRIG_H=4

///////////////////